Snmp Settings - NetComm 3G27WV-R User Manual

Advanced Routing
This page allows you to configure static and dynamic routing rules for your 3G27WV-R.
Advanced Routing – Static
Static Routing allows computers that are connected to your 3G27WV-R to communicate with computers on another LAN segment which are connected to it via another router. To set a rule, you
need to specify the following:
Destination

Range – Select from Host (255.255.255.255) or Net (and then enter the appropriate subnet mask)

Gateway

Interface

Comment to identify the route entered (optional)

Advanced Routing – Dynamic
Dynamic Routing uses the RIP protocol to allow the 3G27WV-R to adapt to changes in the network. RIP enables the device to determine the best route for each packet based on the "hop count"
or number of hops between Source and Destination. To enable Dynamic Routing, select Enable from the drop box and click Apply.

SNMP Settings

SNMP is used to display or collect data from the 3G27WV-R. Various system information including interface statistics, uptime, ane memory usage are available when viewed with an appropriate
SNMP trap monitor.
YML38
www.netcommlimited.com
Figure 24 - Advanced View - Advanced Routing Settings
3G27WV-R
3G27WV-R User Guide
32