Changing Paper Size Of The 2Nd Paper Cassette - Muratec Fax Machine Installation Manual

Installation

Changing paper size of the 2nd paper cassette

The initial setting is as follows.
North American Version : Letter
European Version : A4
1
While pressing the stops in the direction of the arrows as shown in the figure,
pull out the tray of the paper cassette.
Note: Make sure the paper lift lock is released.
2
Remove the three edge guides.
3
Refer to the following table and replace the two springs according to the
desired paper size.
Paper size Spring
A3 Black
B4 Silver
A4 Silver
A4 Silver
F4 Silver
12
Springs
Paper size Spring
Letter Silver
Letter Silver
Legal Silver
11×17 Black
Note: There are two springs under the paper
lifting plate.
Note: The replacement springs are stored in
the bottom of the front side of the paper
cassette.
Note: Always set the springs so the upper end
of the spring fits into the metal clips of
the paper lifting plate and the lower
end fits into the cutout in the bottom
of the paper cassette.
4
Move the edge guides to the desired paper size
and secure them. After reinstalling the edge
guides, recheck the markings in the bottom of
the tray to make sure all three guides are set to
the desired paper size.
5
Load paper and close the paper cassette.
Note: After you change the paper size, you must tell the machine the new setting.
See page 9.
Affixing the labels
Attach the paper size sticker and the cassette number sticker on the front of the
trays.