Yamaha Tyros3 Reference Manual page 85

5
Select the desired Punch In/Out Mode, using the [1 ▲▼]/[2 ▲▼]
(MODE) buttons.
• MANUAL .............. This lets you manually execute Punch In/Out recording by using the
• PEDAL .................. This lets you manually execute Punch In/Out recording by using a
• AUTO ................... This lets you specify the Punch In and Out points, allowing automatic
Specifying the recording range in AUTO mode
If you select AUTO as the punch in/out recording method, specify the recording range and practice the
recording by using the Rehearsal function.
1 Specify the punch in/out range by pressing the [3 ▲▼]/[5 ▲▼] (SET) buttons at the punch in/out
point during the audio song playback.
2
If you move the punch in/out point slightly, use the Nudge function.
In this Nudge function, you can move the punch in/out point slightly (even in millisecond units)
while listening to the playback.
2-1 Press the [7 ▲▼] (NUDGE) button to show the Nudge Play display.
2-2 Use the [DATA ENTRY] dial and [PREV]/[NEXT] button to move the NUDGE DATA POSITION to
the desired punch in/out position while listening to the playback (500 milliseconds loop play-
back before/after the specified point). The [DATA ENTRY] dial lets you adjust the point in sec-
onds and the [PREV]/[NEXT] buttons lets you adjust in milliseconds.
2-3 Press the [7 ▲▼] (MODE) button to select After/Before. "After" repeats 500 milliseconds after
the Nudge Data Position and "Before" repeats 500 milliseconds before the Nudge Data Posi-
tion when you playback the data in the next step.
2-4 Press the [3 ▲▼]/[5 ▲▼] (SET) button to set the moved point. To reset the point to the start/
end point of the data, press the [4 ▲▼]/[6 ▲▼] (RESET) button.
2-5 Press the [8 ▲▼] (CLOSE) button.
NOTE
The smallest possible range of the Auto punch in/out function is 100 milliseconds.
3
Use the REHEARSAL function to practice the recording before the actual recording.
3-1 Press the [8 ▲▼] (REHEARSAL) button. "EXECUTING" is shown above the [8 ▲▼] buttons.
3-2 Press the HARD DISK RECORDER [REC] button and press the [PLAY/PAUSE] button. The audio
song is played back repeatedly starting four seconds before the punch in point to four seconds
after the punch out point. Play the keyboard or sing the desired part in practice. In this
rehearsal function, recording is not started.
3-3 Press the HARD DISK RECORDER [STOP] button.
NOTE
Repeat playback of the rehearsal function is automatically stopped after playing back 99 times.
NEXT PAGE
5
Hard Disk Recorder transport buttons ([REC], [PLAY/PAUSE], etc.).
connected footswitch to the FOOT PEDAL 2 jack.
Punch In/Out recording (see below).
Tyros3 Reference Manual • 85
7
7