Yamaha Tyros3 Reference Manual page 95

8
Select one of the parameters you want to edit by using the [4 ▲▼]/[5
▲▼] buttons, then adjust the value by using the [6 ▲▼]/[7 ▲▼] but-
tons.
If you have selected the REVERB, CHORUS or DSP1 effect block in step 2, you
can adjust the Effect Return Level by pressing [8 ▲▼] button.
To re-select the Effect block, category and type, use the [1 ▲▼]–[3 ▲▼] but-
tons. The re-selected effect configuration is displayed at the upper left side box
in the display.
9
Press the [I] (SAVE) button to call up the display for saving your orig-
inal effect.
10
Use the [3 ▲▼]–[6 ▲▼] buttons to select the destination for saving
the effect.
The maximum number for effects that can be saved differs depending on the
effect block.
11
Press the [I] (SAVE) button to save the effect.
When recalling the saved effect, use the same procedure as in step 5.
10
NOTE
Keep in mind that in some cases noise
may result if you adjust the effect
parameters while playing the instru-
ment.
11
Tyros3 Reference Manual • 95
8
8