Re-Recording A Specific Section-Punch In/Out (Rec Mode) - Yamaha 301 Owner's Manual

Re-Recording a Specific Section—Punch In/
Out (REC MODE)
When re-recording a specific section of an already-recorded Song, use the Punch
IN/OUT function. In this method, only the data between the Punch In point and
the Punch Out point is overwritten with the newly recorded data. Keep in mind
that the notes before and after the Punch In/Out points are not recorded over,
although you will hear them play back normally to guide you in the Punch In/Out
timing. You can specify the Punch In and Punch Out points as measure numbers
beforehand for automatic operation, or manually execute the Punch In/Out record-
ing by using a Foot Pedal or simply by playing the keyboard.
The explanations here apply to the REC MODE display in step 4 of the "Basic Edit-
ing Operation" on page 148.
1
Use the [1 π † ]–[6 π
π † π π † †
recording (see below).
2
While holding the SONG [REC] button, press the desired track but-
ton.
3
Press the SONG [PLAY/PAUSE] button to start playback. Play the key-
board at the Punch In point and stop recording at the Punch Out
point.
4
Press the [I] (SAVE) button to call up the Song Selection display for
saving your data, then save the data in the Song Selection display
(page 63).
■ PUNCH IN settings
NORMAL
FIRST KEY ON
PUNCH IN AT
■ PUNCH OUT settings
REPLACE ALL
PUNCH OUT
PUNCH OUT AT
† ] buttons to determine the settings for re-
π † π π † †
REC
+
Overwrite recording starts when pressing the SONG [PLAY/
PAUSE] button or when you play the keyboard in the Synchro
Standby mode.
The Song plays back normally, then starts overwrite recording as
soon as you play the keyboard.
The Song plays back normally up to the beginning of the indi-
cated Punch In measure, then starts overwrite recording at that
point. You can set the Punch In measure by pressing the [3 π† ]
button.
This deletes all data after the point at which recording is stopped.
The Song position at which recording is stopped is regarded as
the Punch Out point. This setting maintains all data after the
point at which recording is stopped.
Actual overwrite recording continues until the beginning of the
specified Punch Out measure (set with the corresponding display
button), at which point recording stops and normal playback
continues. This setting maintains all data after the point at which
recording is stopped. You can set the Punch Out measure by
pressing the [6 π† ] buttons.
Recording Your Performance
CAUTION
The recorded Song data will
be lost if you select another
Song or turn the power to the
instrument off without exe-
cuting the Save operation
(page 63).
CVP-305/303/301 Owner's Manual 149