Yamaha Tyros3 Reference Manual page 20

8
Execute importing by pressing the [H] (EXECUTE) button.
To cancel importing, press the [8 ▲▼] (CANCEL) button.
9
If you want to import another Wave to this Element, repeat steps 6–8.
10
Set the parameters for the currently selected Element in the KEY
MAPPING display.
1
1
[G]
[1 ▲▼]–
[3 ▲▼]
[4 ▲▼]/
[5 ▲▼]
[6 ▲▼]/
[7 ▲▼]
11
Press the [EXIT] button to return to the WAVE IMPORT display.
If you want to edit another Element, repeat steps 5–10.
12
Press the [8 ▲▼] (VOICE SET) button and edit the Voice Set parame-
ters (page
After you finish editing the Voice Set parameters, press the [EXIT] button to
show the WAVE IMPORT display again.
13
Save the created Voice as a file.
Press the [J] (SAVE) button to call up the SAVE & ASSIGN display, then press
the [G] (SAVE FILE) button to save the Voice.
NEXT PAGE
20 • Tyros3 Reference Manual
Deletes the Wave selected with the [1 ▲▼]–[3 ▲▼] (WAVE) buttons below.
DELETE WAVE
WAVE When more than one Wave has been imported, select the desired one for
editing.
START KEY This determines the lowest key at which the Wave will sound. Use this with
End Key (below) to set the key range for the Wave. You can specify this setting
directly from the keyboard by simultaneously holding down the [4 ▲▼]
(DIRECT KEY) button and pressing the desired key on the keyboard.
END KEY This determines the highest key at which the Wave will sound. Use this with
Start Key (above) to set the key range for the Wave. You can specify this set-
ting directly from the keyboard by simultaneously holding down the [6 ▲▼]
(DIRECT KEY) button and pressing the desired key on the keyboard.
12).
NOTE
If you want to save the Voice at this
point, press the [J] (SAVE) button. The
SAVE & ASSIGN display will appear.
Refer to steps 13–14 below about the
SAVE & ASSIGN display. Each time you
make some change (e.g., add a Wave to
the Element or add an Element to the
Voice), you should save the Voice.
CAUTION
The created Voice will be lost if
you change to another Voice or
you turn the power off without
executing the Save operation.
Make sure to execute the Save
operation.
13
NOTE
Saving the Voice to the USER drive is
not recommended since the USER drive
14
does not have much memory space—
only about 3 MB. It is better to save to
the HD or USB drive.
NOTE
Do not use any special characters
(umlaut, accent, etc.) in the Voice name.