Mini-Gbic With Lc Connector (C1H124-48 Shown) - Enterasys C1H124-24 Installation Manual

Installing Optional Mini-GBICs
Figure 3-2 Mini-GBIC with LC Connector (C1H124-48 shown)
Mini-GBIC (MGBIC-LC01 and MGBIC-LC09)
,
Mini-GBIC top side
7-Pin edge connector (insertion side)
Removing the Mini-GBIC
CAUTION: Carefully follow the instructions in this manual to avoid damaging the
Mini-GBIC and the host device (C1H124-48
The Mini-GBIC and host device are sensitive to static discharges. Use an antistatic wrist
strap and observe all static precautions during this procedure. Failure to do so could
result in damaging the Mini-GBIC or host device. Always leave the Mini-GBIC in the
antistatic bag or an equivalent antistatic container when not installed.
To remove a Mini-GBIC from the C1H124-48 port slot, proceed as follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the Mini-GBIC.
2. Remove the cables connected to the Mini-GBIC.
3. Locate the release tab
shown in Figure
the port slot . For the type of Mini-GBIC shown in
release the Mini-GBIC from the port slot.
3-4 Hardware Installation
Á
À
Ä
Å
under the front end of the Mini-GBIC
3-1, push in on the release tab as far as it will go to release the Mini-GBIC from
Ã
Â
Port slot
,
Mini-GBIC protective dust cover
Release tab
or C1G124-24).
. For the type of Mini-GBIC
Figure 3-2, pull out on the release tab to