Installing The Xfp; Removing The Xfp; Xfp With Lc Connector - Enterasys C2K122-24 Hardware Installation Manual

Installing Optional XFPs

Installing the XFP

To install an XFP that has an LC connector, refer to Figure
1. Hold the XFP with the top side positioned as shown, and the edge connector facing
the port slot.
2. Align the XFP with the port slot.
3. Push the XFP into the port slot until the XFP "clicks" and locks into place.
Figure 3-1
1 XFP
2 XFP, top side
3 Edge connector (insertion side)

Removing the XFP

3-4 Hardware Installation

XFP with LC Connector

Á
Å
Ä
Caution: Do NOT remove the XFP from the port slot without releasing it. The XFP is
released by pulling down on its wire handle. Attempting to remove the XFP without
releasing it can damage the XFP.
The XFP and its host switch are sensitive to static discharges. Use an antistatic wrist strap
and observe all static precautions during this procedure. Failure to do so could result in
damaging the XFP or host switch. Always leave the XFP in the antistatic bag or an
equivalent antistatic container when not installed.
Precaución: NO quite el XFP de la ranura sin antes abrir la traba ubicada en la parte
frontal del XFP. Si lo hace, puede dañar el XFP, puesto que es muy sensible a las
descargas de electricidad estática, al igual que el dispositivo host. Utilice la pulsera
antiestática y tome todas las precauciones necesarias durante este procedimiento. Si no
lo hace, pude dañar el XFP o el dispositivo host. Mientras no esté instalado, mantenga el
XFP en su bolsa antiestática o en cualquier otro recipiente antiestático.
3‐1, and proceed as follows:
Ã
Â
À
4 Port slot
5 Protective dust cover
6 Wire handle (for XFP release)