Completing The Installation - Enterasys C1H124-24 Installation Manual

3.7

COMPLETING THE INSTALLATION

After installing the Enterasys Networks device and making the connections to the network,
proceed as follows:
Initial Logon to Device Management
To initially access device management from your local pc, terminal, or modem connection, proceed
as follows at the displayed startup screen:
-
Enter rw (Read-Write) for Username.
-
At the Password prompt, press ENTER (RETURN).
For details on how to configure the C1H124-48 and C1G124-24 using the command line interface,
refer to the Matrix C Series Configuration Guide. The CLI commands enable you to initially set up
and perform more involved management configurations on the C1H124-48 and C1G124-24.
After the initial configuration, you can also use WebView (Enterasys Networks' embedded web
server) for configuration and management tasks.
The guides are available online at:
http://www.enterasys.com/support/manuals
Once you are confident that the installation is successful, route and secure your cables. If you
require assistance, contact Enterasys Networks using one of the methods described in
Section 1.12.
Completing the Installation
Hardware Installation 3-23