Connecting To A Modem; Connecting A Vt Series Terminal - Enterasys C1H124-24 Installation Manual

4. Turn on the terminal and access the Setup Directory. Set the following parameters on your
terminal:
When these parameters are set, the Startup screen will display. Proceed to
the installation.
Figure 3-15 Connecting a VT Series Terminal
Ã
UTP straight-through cable with RJ45 connectors
RJ45 Console port shown on C1H124-48
3.6.4

Connecting to a Modem

To connect a modem to an Enterasys Networks device modem port
straight-through cable with RJ45 connectors and an optional RJ45-to-DB25 male adapter, and
proceed as follows:
1. Connect the RJ45 connector at one end of the cable
Networks device.
2. Plug the RJ45 connector at the other end of the cable
3. Connect the RJ45-to-DB25 adapter
4. Turn on the modem
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Â
to the communications port on the modem .
and make sure the remote modem
Connecting to Console Port for Local Management
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Á
À
RJ45-to-DB25 VT adapter
VT series terminal
to the Console port
into the RJ45-to-DB25 male adapter .
is ON.
Section 3.7 to complete
(Figure 3-16), use a UTP
on the Enterasys
Hardware Installation 3-19