Hardware Installation; Required Tools - Enterasys C1H124-24 Installation Manual

ELECTRICAL HAZARD: Only qualified personnel should install the C1H124-48 and
C1G124-24.
NOTE: Read the Release Notes shipped with the C1H124-48 and C1G124-24 to check
for any exceptions to the supported features and operation documented in this guide.
This chapter provides the instructions required to install the device. Follow the order of the sections
as listed below to correctly install the device.
•
Unpacking the device
•
Installing options
•
Installing the device (on a shelf or tabletop, or into a standard rack)
•
Connecting to the network
•
Connecting to console port for local management
•
Completing the installation
3.1

REQUIRED TOOLS

A Phillips screwdriver is required to install the device into a rack.
(Section 3.2)
(Section 3.3)
(Section 3.5)
(Section 3.7)

Hardware Installation

(Section
(Section 3.6)
Hardware Installation
3
3.4)
3-1