Connecting Power; Fastening The Device To The Rack - Enterasys C1H124-24 Installation Manual

2. With the mounting brackets attached, position the device between the vertical frame members
of the 19-inch rack as shown in
four mounting screws
Figure 3-5 Fastening the Device to the Rack
Rails of 19-inch rack
3.4.3

Connecting Power

If you experience any problems with this installation, contact Enterasys Networks for assistance.
NOTE: The power supply in the device has automatic voltage sensing that allows
connection to power sources ranging from 100–125 Vac, 2.5 A or 200–240 Vac, 1.25 A,
50/60 Hz.
To connect the device to the power source, refer to
1. Plug the power cord
2. Plug the other end of each power cord
Figure 3-6.
Figure 3-5. Then fasten the device securely to the frame using
(user supplied).
Á
Mounting screws (supplied by user)
into the switch ac power receptacle
into a dedicated grounded ac outlet
À
Figure 3-6 and proceed as follows:
.
Installing the Device
as shown in
Hardware Installation 3-7