Connecting to Console Port for Local Management
4. Turn on the PC and configure your VT emulation package with the following parameters:
When these parameters are set, the Startup screen will display. Proceed to
the installation.
Figure 3-14 Connecting an IBM PC or Compatible
UTP straight-through cable with RJ45 connectors
RJ45 Console port shown on C1H124-48
3.6.3
Connecting to a VT Series Terminal
To connect a VT Series terminal to an Enterasys Networks device Console port
a UTP straight-through cable with RJ45 connectors and an optional RJ45-to-DB25 female
adapter, and proceed as follows:
1. Connect the RJ45 connector at one end of the cable
Networks device.
2. Plug the RJ45 connector at the other end of the cable
adapter .
3. Plug the RJ45-to-DB25 adapter
3-18
Hardware Installation
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Â
Ã
to the port labeled COMM on the VT terminal .
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Á
À
RJ45-to-DB9 PC adapter
PC
to the Console port
into the RJ45-to-DB25 female
Section 3.7
to complete
(Figure
3-15), use
on the Enterasys