HP Integrity Superdome 2 User Manual page 168

215 Could not reset the blade's efuse.
216 Firmware Update in progress. Sign In disabled.
217 An error occurred while setting the enclosure PDU type.
218 An error occurred while setting the enclosure part number.
219 An error occurred while setting the enclosure serial number.
221 Not a valid request for this device type.
222 The Active and Standby Onboard Administrators are not the same hardware build.
223 The other Onboard Administrator status and firmware was reported as unknown. This can be
caused by trying to perform a firmware update before both Onboard Administrators are fully
booted, or if the standby Onboard Administrator firmware version is less than v2.00.
224 Failed to create firmware image.
225 The Active and Standby Onboard Administrators already have the same firmware version
installed.
226 The other Onboard Administrator's firmware version must be v2.10 or later for this feature
to be available.
227 The requested user cannot be removed from iLO because it is the last Administrator account.
228 The requested user cannot be added to iLO because iLO's local accounts have been disabled.
229 The requested user cannot be added to iLO because the maximum number of local accounts
already exists.
230 Unable to remove one or more of the specified SNMP Traps because they do not exist.
231 Reset Factory Defaults in progress. Sign In disabled.
235 The Onboard Administrator is initializing. Sign In disabled.
236 Cannot retrieve media status.
237 The requested device is not ready.
238 Power off (or remove) partner blade.
239 The current firmware does not support this operation.
240 Serial Number update requires newer firmware version. See 'UPDATE DEVICE' command.
241 The requested device is not present.
242 The operation cannot be performed on the requested device.
243 iLO's license information cannot be retrieved because iLO's XML Reply has been disabled.
244 SSH is disabled on this blade.
245 A virtual media applet is connected. The applet must be disconnected to complete this
operation.
246 Invalid SNMP Write Community string.
247 Invalid SNMP Read Community string.
252 No CA Certificates present.
255 No Certificate mapped to Administrator.
257 The user certificate could not be verified. Please upload the corresponding CA certificate.
260 This operation cannot be performed when AlertMail is disabled.
261 This operation cannot be performed when the AlertMail settings have not been configured.
262 This operation cannot be performed when SNMP is disabled.
263 A certificate must be mapped to Administrator or ldap must be enabled with one of the
configured groups with administrator privilege, to enable two-factor authentication.
265 Certificate has not been mapped to this user account.
168 Troubleshooting