HP Integrity Superdome 2 User Manual page 165

69 Getting interconnect status for the submitted interconnect failed.
70 An error occurred while accessing the connected user for the requested blade.
71 An error occurred while reading the lockfile for the submitted blade.
72 The submitted E-mail address is not valid.
73 Libem is not able to talk to iLO.
74 Downloading the submitted file failed.
75 The certificate could not be verified.
76 Could not save the authorization keys.
77 The SSH key size is not correct.
78 Could not ping the requested url.
79 Could not generate the CSR.
80 Could not generate the SSO
81 Could not read the fingerprint.
82 Could not get SSH key.
83 The box is already enabled.
84 The box is already disabled.
85 The system is already in DHCP mode.
86 The system is now in static IP mode.
87 Could not clear the system log.
88 Could not restore the factory settings.
89 Could not read the configuration file.
90 Could not write to the configuration file.
91 Could not configure the MAC address.
92 The submitted url is not valid.
93 Could not update the firmware with the submitted image file.
94 Unable to acquire the rack topology.
95 Invalid domain.
96 The EBIPA device is bad.
97 Connecting to the blade's iLO failed.
98 Sending the RIBCL command to the requested blade failed.
99 Could not find the requested element in the RIBCL response.
100 Could not find the requested attribute in the RIBCL response.
101 Could not find the starting boundary in the RIBCL response.
102 Could not find the ending boundary in the RIBCL response.
103 Could not determine the IP address of the management processor for the requested blade.
104 Could not locate a Primary NTP server.
105 You must set at least one (1) trusted host before enabling trusted hosts.
106 Could not set the LCD pin.
107 Could not create the RIBCL request.
108 This error message should be taken from the soap errorText (varies).
109 Getting power information failed.
1 10 Setting power information failed.
Onboard Administrator error messages 165