Reducing Printer Noise; Adjusting Sleep Mode - Konica Minolta bizhub 4000P User Manual

Reducing printer noise

Use Quiet mode to reduce the printer noise.
1. From the printer control panel, navigate to:
>Settings >
2. Select a setting you want.
Use
On
Off
3. Press .

Adjusting Sleep mode

To save energy, decrease the number of minutes before the printer enters Sleep mode. Select from 1 to
120. The factory default setting is 30 minutes.
Note: The printer still accepts print jobs when in Sleep mode.
Using the Embedded Web Server
1. Open a Web browser, and then type the printer IP address in the address field.
Notes:
- View the printer IP address in the TCP/IP section in the Network/Ports menu. The IP address
appears as four sets of numbers separated by periods, such as 123.123.123.123.
- If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2. Navigate to:
Settings >General Settings >Timeouts
3. In the Sleep Mode field, enter the number of minutes you want the printer to wait before it enters
Sleep mode.
User's Guide
>Settings > >General Settings > >Quiet Mode >
To
Reduce printer noise.
Notes:
• Print jobs will process at a reduced speed.
•
Printer engine motors do not start until a
document is ready to print. There is a short delay
before the first page is printed.
Use factory default settings.
Note: This setting supports the performance
specifications of the printer.
- 63 -