Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of any of the following possible changes in the printer:
•
The printer firmware has been updated.
•
The tray for the print job is removed.
•
The print job is sent from a flash drive that is no longer attached to the USB port.
From the printer control panel, select Continue to clear the message. Press
Defective flash detected [51]
Try one or more of the following:
•
Replace the defective flash memory card.
•
From the printer control panel, select Continue to ignore the message and continue printing. Press
to confirm.
•
Cancel the current print job.
Error reading USB drive. Remove USB.
An unsupported USB device is inserted. Remove the USB device, and then insert a supported one.
Error reading USB hub. Remove hub.
An unsupported USB hub has been inserted. Remove the USB hub, and then install a supported one.
Imaging unit low [84.xy]
You may need to order an imaging unit. If necessary, select Continue on the printer control panel to clear
the message and continue printing. Press
Imaging unit nearly low [84.xy]
If necessary, select Continue on the printer control panel to clear the message and continue printing.
Press
to confirm.
Imaging unit very low, [x] estimated pages remain [84.xy]
You may need to replace the imaging unit very soon. For more information, see the "Replacing supplies"
section of the User's Guide.
User's Guide
to confirm.
- 150 -
to confirm.