GE JGB928 Owner's Manual & Installation Instructions page 53

ge.com
Possible Causes What To Do
Upper oven light Light bulb is loose or defective. * Tighten or replace the bulb.
doesnot work
Plug on range is not completely * Make sure electrical l)lug, is l)lugged,, into a live, properly
h_serted ha the electrical outlet, grounded outlet.
Upper oven millnot The oven temperature is too * ?dlow the range to cool to room temperature mad
self-clean high to set a self-cleml operation, reset the controls.
Oven controls improperly set. * See the
Using the self-cleaning upper oven section.
"Crackling"
or This is the sound of the * This is normal.
"popping" sound
metal heating mid cooling
during both the cooking and
cleaning functions.
Excessive smoking Excessive soil. * Touch the CLEAR/OFF pad. Open the windows to
rid the room of smoke. Wait until the LOCKED DOOR
light goes off. Wipe up the excess soil and l'eSet the
cle;lU cycle.
Oven door will not open Oven too hot. * Allow the oven to cool below hwkiug temperature.
after a clean cycle
Oven not clean after
a
Oven conlrols not properly set. * See the
Usingthe self-cleaningupper oven
se('ti(m.
clean
cycle
Oven was heavily soiled. * Clean up heavy spilhwers before starting the clean
cycle. Heavily soiled ovens may need to sell=clean
again or for a hmger period of time.
"LOCK DOOR" flashes The self-clean cycle has been * Close the oven door.
in the display
selected but the door is not
closed.
LOCKED DOOR
light
The oven door is locked * Touch tile CLEAR/OFF pad. Allow the ()\'ell to cool.
is on when you want because the temperature
to COOk
inside the oven has not
dropped below the
locking temperature.
"F--andanumberor You have a fm_ction error code. * TotwhtheCLEAR/OFFpad.?dh)wtheoveutocooltbr
letter"flash in the display one hotu: Put the oven back into operation.
If the function code repeats. * Disconnect all power to the range for 5 minutes
and then reconnect power. ]f the flmctiou error
code repeats, call fin" service.
Oven shelves are The nickel shelves (if so equipped) * Apply a small amotmt of vegetable oil to a paper
difficult to slide
were cleaned in a self-cleml cycle, towel and wipe the edges (>f the oven shelves with
The gray porcelah_-coated shelves the paper towel. Do not spray with Pare": or other
(if so equipped) were improperly lul)ricaut sprays.
cleaned,
"Probe"appears in
thedisplay(somemodels)
This is reminding you to enter a
probe temperature after plugging
in the probe.
• Enter a probe temperature.
53