GE JGB928 Owner's Manual & Installation Instructions page 50

Installation Instructions
[] INSTALLING THE ANTI-TIP
DEVICE
-& WARNING!
• Range must be secured with an approxed Anti-
Tip dexice.
• Unless properly installed, the range could be
tipped b) )ou or a child standing, sitting or
leanino_ on
_111 open door,
• After installing the Anti-Tip dexice, xerilk' that it
is in place by carefiflly attempting to tilt the
range forward,
• This range has been designed to ineet all
recognized industr) tip standards for all normal
conditions.
• The use of this dexice does not prechMe tipping
of the ranoe_ when not properl) installed.
• If the Anti-Tip dexice supplied with the range
does not fit this application, use the tmixersal
Anti-Tip dexice _,_B2X7909.
A. Mark the wall where the RIGHT EDGE of the range
is to be located. Be sure to allow fin" the cotmtertoi_
overhang if you intend to install the range next to
cabinets.
Slotted head
Markededgeof range
2½ toward the
B. i,ocate the outside edge, of the device ' J "
center of the range ti'om the marked edge of the
I'll n )e
C. Using the dexice as a template, mark the position of
the hole for the screw.
D. For wood construction, drill a pih)t hole at an angle
of 20 degrees from the horizontal. A nail or awl may
be used if a drill is not axailable.
Mount the Anti-Tip dexice with the screw proxided.
For ceu/en[ or concrete constrtlction, VOtl
will
need
a 1/4" x 1½" lag bolt and a 1/2" O.D. sleeve anch(n;
which are not provided. Drill the recommended size
hole for the hardware.
[] INSTALLING THE ANTI-TIP
DEVICE (CONT.)
Wallhoard
Backof range
Wood screw
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. The bolts must
be properly tightened as recommended for the
hardware.
E. Slide the range against the wall, and check fi)r
proper installation by grasping the front edge of the
cooktop and carefidly attempting to tilt the range
fin'ward.
WHEN ALL HOOKUPS ARE
COMPLETED
Make sure all controls are left in the off position. Make
sure the flow of combustion and ventilation air to the
range is unobstructed.
CONVERTING TO LP GAS (or
converting back to natural gas from LP)
This rmlge leaves the factory set for use with natural
gas. If you want to convert to LP gas, the conversion
must be performed by a qualified LP gas installer.
The conversion insn uctions and 12 orifices can be
found attached to the range next to the pressure
regulator:
Keep these instructions and the orifices in case you
_V}IIIt to con_,ert back to nattlral gas.
5O