GE JGB928 Owner's Manual & Installation Instructions page 49

Installation Instructions
[] ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY
Air adjustment shutters for the top and bottom burners
regulate the flow of air to the flames.
The air a(!justment shutter for the top (broil) burner is
in the center of the rear wall of the oxen.
ustmellt
shutter
The shutter for the bottom (oven) burner is near the
back wall behind the drawer. Remove the drawer. See
the Care and cleaning of the range section.
To adjust the flow of air to either burner, loosen the
Phillips head screw and rotate the shutter toward open
or closed position as needed.
The flames for the top (broil)
burner
should be steadx
with approximately l" blue cones and should not
extend out oxer the edges of the burner baffle.
To detem_ine if the bottom burner flames are burning
properl B remove the oven bottom. Flames should have
approximately 1" blue cones and, if range is SUl)plied
with natm'al gas, should burn with no yellow tipping.
(_._]th most I.P gas, small vellow tips at the end of outer
cones are noi_/nal.) Flalnes should not lilt ott burner
ports. If lilting is observed, gradually reduce air shutter
opeldng until flalnes are stabilized.
[] ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY (CONT.)
To remove the oven bottom:
A. Remove the knm'led screws holding down rear of the
o'_en bottoiil,
B. (;rasp the oxen bottom at finger slots on each side.
C. i.itt the rear of the oxen bottom
enough to clear the
lip of the range franle, push it back, and then pull it
tip and ot/t.
[] LEVELING THE RANGE
a.
ram,e where it will be installed.
Raise
, raooe
range
Install the oven shelxes in the oxen and position the
Lower
range
(on some models)
(on some models)
B. Check
fin" levelness
by placing a spirit
level or a cup,
partially filled with water, on one of the oven shelves.
If using a spilit level, take two readings--with the
level placed diagonally first in one direction and
then the other.
C. ]_,emove the drawer.
See the Care and cleaning of the
range section. The fl'ont leveling legs can be a(!justed
ti'oln the bottonl and the rear legs can be a(!iusted
ti'om the top or the bottom.
D. Use an open-end or a(!justable wrench to a(!just the
lexeling legs tmtil the range is lexel.
E. After the range is lexel, slide the range awax from the
wall so that the Anti-Tip dexice can be installed,
49