GE JGB928 Owner's Manual & Installation Instructions page 31

Burner Caps and Heads
NOTE: Before removing the burner caps
and heads, remember their sloe and location.
Replace them/n the same location after
cleaning. The top sides of the Right Front,
R/_Tht R ear and Left Front burner heads are
marked with the letters "RF," "RR" and
"LE"
respectively, to aid reassembly,
Burner caps
I,ifl off when cool. Wash burner caps
in hot, soapy water and rinse with clean
water. You may scour with a plastic
scouring pad to remove burned-on
food particles.
Burner heads
The slits in the burner heads of your
cooktop must be kept clean at all times.
Clooged<.,, or (lirt_, burner I)°rts' or
electrodes will not allow the burner to
operate properly.
Any spill on or around an electrode must
be carefully cleaned. Take care to not hit
an electrode with anything hard or it
could be damaged.
You should clean the burner caps,
burner heads and burner bases routinel>
especially after bad spillovers, which
could clog the openings in the burner
heads. I,ifl off when cool.
To remove burned-on food, soak the
burner heads in a solution of mild liquid
detergent and hot water fin" 20-30
II/illtltes. For iilore sttlbborll staillS_
use a toothbrush.
After cleaning
geli)re putting the burner caps and
heads back, shake out excess water and
then dry them thoroughly by setting in a
warm oven fin" 30 minutes.
NOTE." Do not use steel wool or scounbgpowders
to clean the burners or electrodes. Thiscan damage
the burners and electrically short the electrodes.
ge.com
Replacement
The top sides of the Right Front, Right
Rear and I,efl Front burner heads are
marked with the letters "I_.F," "RR' and
"I,E " resI)ectively, to aid reassembly.
Mediumhead
(n0tmarked)small head
andcap andcap
Fr;nt of rang
Largehead Extralarge
and cap headand
cap
Replace the burner heads on the bases
matching the letters. ]),el)lace the caps on
the heads. Make sure that the caps and
heads are replaced in the correct
location. There is one small, one
medium, one large and one extra large
head and cap.
_ocamr nins_
When replacing make sure the Iocator pflTs in the
burner head are seated in the pin slots of the burner
base. Rotate the burner head around the burner base
until it is level and securely seated.
31