GE JGB928 Owner's Manual & Installation Instructions page 38

iiiiiiiiiiiii"::i_'i_5:i:i:i:i:i:i:i:i:ilili_ii_!!i_!!
-€
q
#_.
m
Care and cleaning of the range.
Oven Shelves and Drawer Racks
If w)ur oven is equipped with nickel oven
shelves, they should be removed fl'om the
oven befi)re begimfing the sel6clean cycle,
To clean the nickel shelves, use an abrasive
cleanser, _Mter cleaning, rinse the shelves
with clean water and (h_' with a clean cloth,
If the shelves ever become hard to slide,
wipe the shelf edges or oven shelf supports
with vegetable oil,
If yore" oven is equipped with gray porcelain-
coated sheNes, they may be cleaned in the
oven dining the self:clean cycle,
They may also be cleaned by using an
abrasive cleansex: AJter cleaning, dnse the
shelves with dean water and dxw with a
clean cloth. If the shelves ever l_ecome hard
to slide, wipe the shelf edges or oven shelf
supports with vegetable oil.
Wire cover holder.
Oven Light Replacement
CAUTION: B efore replaclbg yourovenhghtbuib,
disconnect thee/ectncai powerto therange at the
mainfuseorckcuitbreaker p ane/. B esuretoiet the
h#htcoverandbuibcoo/compiete/y
The oven light bull) is covered with a
remox_d)le glass cover that is held in place
with a bail-shaped wire. Remove the oven
(lore, if desired, to reach cover easily:
Toremove:
V_ Hold a hand under the coxer so it
ii i
doesn't fifll when released. _._ith
finge_ of the same hand, fimfl) push
back the wire coxer holder; Lift off
the
CO_, eI',
Do not remove any screws to remove
the cover.
] Do not touch hot bull) with a wet
cloth, Replace bulb with a 40-watt
household appliance bull),
Toreplace cover:.
[] Place it into the groove of'the light
receptacle. Pull the wire fin'ward to the
center of the cover tmtil it snaps into
place. _]_en in place, the wire holds
the cover firefly. Be certain the wire
is in the depression in the center of
the cover.
Com_ect electrical power to the range.
[]
38