GE JGB928 Owner's Manual & Installation Instructions page 37

g_com
Vent appearance and location varF
Oven Air Vents
Never block tile vents (air openings) of tile
range. Tile}' provide tile air inlet and outlet
that are necessa_ T fin" the range to operate
properly with correct COll/btls[ion.
_dr openings are located at the rear ot
tile cooktop, at tile top and bottom ot tile
oven doo_; and at tile bottom of tile range,
under
tile lower oven (h'awe_:
CONTROL LOCKOUT
Upper Control Panel
On models so equipped, lock outthe touch
pads before cleaning.
See tile Control Lockoutinlbmmtion
in tile
Special features of your oven control section
in this manual.
Clean up splatte_ with a (lamp cloth.
Yell i/lay also rise a
glass
cleanei /
Remove heavier soil with waml soapy water:
Do not use abrasives of anv kind.
Unlock the touch pads after cleaning.
Surface burner &?ob
_J
Lowerovendrawerknob
Lower Control Panel (Front Manifold Panel) and Knobs
It's a good idea to wipe tile control panel
atier each
tlse of
tile oven. Use a damp
cloth to clean or iJnse. For cleaning, rise
mild soap and water or a 50/50 solution el
vinegar and wam_: For dnsing, use clean
water: Polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid
cleane_, plastic scouring pads or oven
cleaners on tile control panel--they will
damage tile finish.
Do not try to bend knobs by pulling them
up or down or by hanging a towel or other
such loads. This can danmge the gas \;dye
shaft.
Tile control knobs may be removed fin"
easier cleaning. To remove a knob, pull it
straight off tile stem. If knob is difticult to
remove, place a towel or dishcloth between
tile knob and control panel and pull genfl>
Wash tile knobs in soap and water or a
vinegar and hot water solution.
Metal parts can be cleaned with soap and
water: Do not use steel wool, abrasives,
_lI//IllOIli_l_ acids or coi//illercial oven
cleane_. Dry with a soft cloth.
NOTE" Thelowerovendrawercontrol k nobis not
interchangeable with thesurface burner knobs.Be
sureto raY_sta// thelowerovendrawerknobto the
originallocation.Thelowerovendrawerknobmay
be identified by theredfine.Surface burner knobs
havea white fine.
37