Transfer Roll Removal - Lexmark E238 Service Manual

4511-xxx

Transfer roll removal

Note: Handle or touch the transfer roll as little as possible.
1. Open the front access cover.
2. Place a sheet of clean paper around the transfer roll to protect it.
3. At the right side of the transfer roll, squeeze the holder arms with the
left hand while lifting. Stop when the holder is unlatched.
4. At the left side of the transfer roll, squeeze the holder arms with the
right hand while lifting with the left hand. Stop when the left holder is
unlatched.
5. With a hand at each end, lift the transfer roll out. The springs should
remain in place. Replace the right spring with the transfer roller FRU.
Reinstallation note: Verify the springs are inserted into the bearings when
re–installing.
4-50
Service Manual