Sub error codes (continued)
First 6 bytes sub
error code data
(xx can be any
value)
84 xx 30 00
00 00
84 xx 3B x1
x2 x3
89 00 01 00
00 00
Explanation
Input sensor never became uncovered
from page ahead while trying to feed
media out of path during warm-up. Paper
originally detected at option tray pass thru
sensor.
• Clear the media or debris from the
printer.
• Enter Diagnostics, and perform the
Base Sensor test to verify the proper
function of the input sensor. See
"Accessing service menus" on
page 3-2
for models E238, E240, or
E240n or
"Accessing service
menus" on page 3-14
E340 or E342n. See
test" on page
Media picked from the manual source
failed to reach the input sensor.
The exit sensor at the fuser is activated by
a piece of media indicating there is a
piece of media in the paper path during
warmup.
Check for media in the exit of the fuser
assembly or redrive assembly. Feed a
sheet of paper, and if the same error
occurs after clearing the fuser, or the
same error occurs when no media is
present, check the exit sensor assembly.
Turn the printer off, enter the diagnostic
tests menu, and select the base sensor
test. Select output sensor, and check the
sensor for correct operation.
for models
"Base sensor
3-28.
Diagnostics—E340 and E342n
4511-xxx
Possible
error
message
200
251
202
2-75