Paper Never Picks - Lexmark E238 Service Manual

Paper picks but stops halfway through the printer
FRU
Input sensor #1 (under
print cartridge
assembly) and
Input sensor #2
(manual)

Paper never picks

FRU
Paper feed (pick tires)
Action
Make sure the input sensors are working
properly.
Check for a broken or stuck flag on the input
sensors.
Make sure the cables are seated on the
controller card at J9 (Tray 1 input) and J20
(manual input).
Check for about +5 V dc on pin 1 at J9 (Input
sensor #1) and pin 1 at J20 (Input sensor #2).
• If correct, replace the input paper feed sensor.
• If these voltages are not correct, replace the
controller card.
Action
Open the left cover, and verify the solenoid and
clutch are functioning when an attempt is made
to feed the paper.
Make sure the rubber tires are installed and
clean.
Replace if necessary.
Diagnostics—all models
4511-xxx
2-95