Lexmark E238 Service Manual page 108

4511-xxx
Sub error codes (continued)
First 6 bytes sub
error code data
(xx can be any
value)
89 xx 03 x1
x2 x3
89 xx 04 x1
x2 00
89 xx 0D 00
x2 x3
8A 39 x1 x2
x3 x4
2-76
Service Manual
Explanation
The exit sensor did not detect the trailing
edge of the media.
(x1=bit7:filtered exit sensor state;
bits 6–0:H1(time exit sensor covered),
x2=suspect gap measurement at input
sensor, x3=Low(time exit sensor
covered).)
• This failure can be caused by a broken
fuser exit sensor flag.
• This may also be caused by erratic
operation of exit sensor flag or exit
sensor or a defective piece of media.
The exit sensor never actuated from the
sheet going through the fuser before the
next page entering the sensor.
(x1=media size, x2=GeneralFlags1.)
The fuser exit sensor bounced.
(x2 + x3=paper path location.)
Check the exit sensor for correct
operation. Check the sensor cable to J16
on the controller card. Also, the controller
card may be failing.
Printhead driver IR: LE at image point
based on lock assumption that proved to
be wrong.
(x1=printead type, x2=1 if lock,
x3, x4=time since printhead start.)
Possible
error
message
202
202
202