Ack Character - Datalogic QuickScan QS6500 Product Reference Manual

Interface Related Features
RS-232 Interface Features — cont.

ACK Character

START
MODE
Sets the ACK character from the set of ASCII charac-
ters or any hex value from 0 to FF. To configure this
feature, scan the "START" bar code above to place
the unit in Programming Mode, then the "Set ACK
Character," followed by the digits from the Alphanu-
meric table in
representing your desired character. Accept your
selection by scanning the "SET" bar code below and
finally, exit programming mode by scanning the
"END" barcode below.
DEFAULT SETTING FOR THIS FEATURE: 06 (0x06)
Set ACK
Character
SET
END
4-18
BARCODE
Appendix B, Alpha-Numeric Pad
®
QuickScan QS6500/QS6500 BT