Symbologies
Telepen — continued
Code I.D. Selection
The Code I.D. for this symbology consists of one or two user-selectable
ASCII characters. It can be appended previous to or following the trans-
mitted Telepen bar code data depending on how this feature is enabled.
Example: Setting the Telepen Code I.D.
To configure this feature:
1. Determine which character(s) you would like to use to represent
the Telepen symbology. Reference
to find the corresponding hex values for your chosen charac-
Chart
ter(s). In this example we'll set a Code I.D. of "S" to represent
Telepen. The value from the table corresponding to ''S' is 53. This
value will be used in a step to follow.
2. Scan the START bar code
3. Scan the SET TELEPEN CODE I.D. bar code.
4. Turn to
Appendix B, Alpha-Numeric Pad
and '3' (the value determined in an earlier step to represent 'S').
5. Scan the SET bar code to accept the digits scanned.
6. Turn to the
Data Editing
TION: BEFORE BAR CODE DATA label.
Features configured using the
universal and will affect all symbologies.
NOTE
7. Scan the END bar code to exit Programming Mode.
8. The resulting message string for scanned Telepen labels would
appear as follows:
Scanned bar code data:
Resulting message string output: S0123456789123
6-160
Appendix A, ASCII Conversion
and scan the bar codes '5'
chapter and scan the CODE ID POSI-
Data Editing
0123456789123
®
QuickScan
QS6500/QS6500 BT
chapter are