Interface Related Features
RS-232 Interface Features — cont.
ACK NAK Retry Count
START
MODE
This feature sets the number of times for the imager
to retry a label transmission under a retry condition.
0 = No retry
1 - 254 = Retry for the specified number of times
255 = Retry forever
To configure this feature, scan the "START" bar code
above to place the unit in Programming Mode, then
the "Set ACK NAK Retry Count," followed by the dig-
its from the Alphanumeric table in
Alpha-Numeric Pad
count. Accept your selection by scanning the "SET"
bar code below and finally, exit programming mode
by scanning the "END" barcode below
DEFAULT SETTING FOR THIS FEATURE: 03
Set ACK
Nak Retry
Count
SET
END
4-22
BARCODE
Appendix B,
representing your desired retry
®
QuickScan
QS6500/QS6500 BT