Code I.d. Selection; Example: Setting The Matrix 2 Of 5 Code I.d - Datalogic QuickScan QS6500 Product Reference Manual

Matrix 2 of 5 (Eur) — continued

Code I.D. Selection

The Code I.D. for this symbology consists of one or two user-selectable
ASCII characters. It can be appended previous to or following the trans-
mitted Matrix 2 of 5 bar code data depending on how this feature is
enabled.

Example: Setting the Matrix 2 of 5 Code I.D.

To configure this feature:
1. Determine which character(s) you would like to use to represent
the Matrix 2 of 5 symbology. Reference
to find the corresponding hex values for your chosen
sion Chart
character(s). In this example we'll set a Code I.D. of "B" to repre-
sent Matrix 2 of 5. The value from the table corresponding to ''B'
is 42. This value will be used in a step to follow.
2. Scan the START bar code
3. Scan the SET MATRIX 2 OF 5 CODE I.D. bar code.
4. Turn to
Appendix B, Alpha-Numeric Pad
and '2' (the value determined in an earlier step to represent 'B').
5. Scan the SET bar code to accept the digits scanned.
6. Turn to the
Data Editing
TION: BEFORE BAR CODE DATA label.
Features configured using the
universal and will affect all symbologies.
NOTE
7. Scan the END bar code to exit Programming Mode.
8. The resulting message string for scanned Matrix 2 of 5 labels
would appear as follows:
Scanned bar code data:
Resulting message string output: B0123456789123
Product Reference Guide
Matrix 2 of 5 (Eur)
Appendix A, ASCII Conver-
and scan the bar codes '4'
chapter and scan the CODE ID POSI-
Data Editing
0123456789123
chapter are
6-111