Code 4/5 Data Group Characters - Datalogic QuickScan QS6500 Product Reference Manual

Symbologies
Code 4/5 — continued

Code 4/5 Data Group Characters

Once you've pre-set your desired Data Group Characters
feature found in
Group Characters
to output up to two of those pre-sets whenever a Code 4 or Code 5 bar
code is scanned.
The options in this section set Data Group Characters
for Code 4/Code symbologies ONLY. If you wish to
enable this feature for additional symbologies, turn to
the options in the section specific to the other symbol-
NOTE
ogy(s).
To set this feature:
1. Determine which Data Group pre-set(s) to output. You can select
up to two from the following:
Data Group 1 * Data Group 2 * Data Group 3 * Data Group 4
For example, your choice might be Data Group 2 only; Data
Groups 1 and 3; Data Groups 3 and 4; or no Data Groups.
2. Scan the START bar code to place the imager in Programming
Mode.
3. Scan the SET CODE 4/5DATA GROUP CHARACTERS bar
code.
4. Turn to
Appendix B, Alpha-Numeric Pad
senting the Data Group designation(s) chosen in the first step
above. A digit of value zero (0) selects "no group." For example,
scanning 3 and 0 would output only the character(s) set for Data
Group 3 whenever Code 4 or Code 5 bar code was scanned. Scan-
ning digits 1 and 2 would output both Data Groups 2 and 3. To
select no Data Groups at all, scan 0, then 0 again.
5. Scan the SET bar code to accept the digits scanned.
6. Scan the END bar code to exit Programming Mode.
1. In that chapter, you can select which character(s) and position(s) to place Data Characters
within scanned data output.
6-206
1
, you can choose
Chapter 5, Data Editing
and scan the digits repre-
®
QuickScan QS6500/QS6500 BT
using the
Data