Symbologies
EAN-8 — continued
Code I.D. Selection
The Code I.D. for this symbology consists of one or two user-selectable
ASCII characters. It can be appended previous to or following the trans-
mitted EAN-8 bar code data depending on how this feature is enabled.
Example: Setting the EAN-8 Code I.D.
To configure this feature:
1. Determine which character(s) you would like to use to represent
the EAN-8 symbology. Reference
to find the corresponding hex values for your chosen charac-
Chart
ter(s). In this example we'll set a Code I.D. of "FF" to represent
EAN-8. The hex value from the table corresponding to 'F' is 46.
This value will be used in a step to follow.
2. Scan the START bar code
3. Scan the SET EAN-8 CODE I.D. bar code.
4. Turn to
Appendix B, Alpha-Numeric Pad
and '6' (the value determined in an earlier step). Scan the bar codes
'4' and '6' a second time to represent the second 'F' needed to
identify the Code I.D.
5. Scan the SET bar code to accept the digits scanned.
6. Turn to the
Data Editing
TION: BEFORE BAR CODE DATA label.
Features configured using the
universal and will affect all symbologies.
NOTE
7. Scan the END bar code to exit Programming Mode.
8. The resulting message string for scanned EAN-8 labels would
appear as follows:
Scanned bar code data:
Resulting message string output: FF02345673
6-34
Appendix A, ASCII Conversion
and scan the bar codes '4'
chapter and scan the CODE ID POSI-
Data Editing
02345673
®
QuickScan
QS6500/QS6500 BT
chapter are