Setup Software; Installing The Software; Configuring The Settings Of The Personal Computer - Panasonic AWRP120 Operating Instructions Manual

Remote camera controller
Table of Contents

Advertisement

Setup Software

Setup Software is an application for configuring the settings for connecting the unit with the remote cameras and switcher from a personal computer .
The settings can be configured while confirming each item in a list .
z The settings for connecting the unit with the remote cameras and switcher can also be configured using just the unit . For how to configure the settings
z
on the unit, refer to "Settings for connecting with the remote cameras and switcher" in <Basics> (page 29) .
Notes
When using Setup Software to configure the settings from a personal computer, observe the following .
z Do not perform any operation on the unit .
z
z Do not start Setup Software on any other computer in the same network .
z
z Do not use "Easy IP Setup Software" supplied with AW‑HE120, AW‑HE60, and AW‑HE50 .
z

Installing the software

This section describes how to install Setup Software .
1 .
Insert the CD‑ROM supplied with the unit into the CD‑ROM drive of the personal computer on which the application is going to be installed .
2 .
Copy the entire folder containing "Setup Software" on the CD‑ROM to the hard disk drive of the personal computer .
3 .
Double‑click "RP120Tool .exe" in the copied "Setup Software" folder to start Setup Software .

Configuring the settings of the personal computer

Configure the following settings of the personal computer before connecting it to the unit .
IP address
: Set an IP address that is not a duplicate of the IP address set on the unit or any IP address set on the devices (remote
Subnet mask
: Set the same subnet mask as that set on the unit .
Default gateway
: Set the same default gateway as that set on the unit .
Confirm the IP address, subnet mask, and default gateway set on the unit in RP SETUP menu [25] .
IP address
: "7 . IP ADDRESS" item
Subnet mask
: "8 . SUBNETMASK" item
Default gateway
: "9 . GATEWAY" item
cameras, switcher, etc .) connected within the same subnet .
45

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aw‐rp120g

Table of Contents