Panasonic AWRP120 Operating Instructions Manual page 44

Control interface for external devices
Registering camera numbers to CAM OUT1 to
CAM OUT10
1 .
Press the MENU button .
2 .
Open GPI OUT menu [45] .
3 .
Turn the F1 dial to display the "1 . CAM OUT1" item .
1 .C AM OU T 1
4 .
Turn the F2 dial to select the camera number to set for
CAM OUT1, and then press the F2 dial to confirm the
selection .
Camera number : Select from CAM1 to CAM100 .
5 .
Turn the F1 dial to display any of the "2 . CAM OUT2"
to "10 . CAM OUT10" items and then register a camera
number .
z Repeat steps 3 to 4 .
44
(continued)
C A M 1
„ REMOTE
„
(JST: JEY‑9P‑1A3F(LF)(SN))
You can connect a personal computer or other external device to select
the camera group, select the remote camera, and recall preset memory
or tracing memory .
For further details, contact your dealer .
Pin number
1 5
6 9
„ TO PAN/TILT HEAD 1 to 5 connectors
„
(RJ‑45)
Connect remote cameras with support for a serial connection to these
connectors using LAN cables .
Connect them with straight cables (category 5 or better shielded cable) .
Pin
Signal name
number
1 GND
2 TALLY
3 TXD –
4 RXD –
5 RXD+
6 TXD+
7 NC
8 NC
z TALLY (pin number: 2) specifications
z
Voltage withstand: Max . 24 V DC
Current: Max . 50 mA
„ LAN connector (RJ‑45)
„
Connect a remote camera, switcher, or computer that supports an IP
connection to this connector with a LAN cable .
When directly connecting a device to the unit, use a crossover cable
(category 5 or better shielded cable) .
When connecting via a hub (switching hub) or other device, use a
straight cable (category 5 or better shielded cable) .
Signal name
1 ‑‑‑
2 RXD IN
3 TXD OUT
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 ‑‑‑
Description of signal
Frame ground
Tally output (open collector)
Send data (–)
Receive data (–)
Receive data (+)
Send data (+)
Not used
Not used