Panasonic AWRP120 Operating Instructions Manual page 49

Setup Software
(continued)
14 15
12 RECEIVE PORT NO
Set the port numbers for the unit to receive camera information
update notifications from remote cameras .
Possible setting range: 61000 to 65535
z Set 10 port numbers because update notifications are received
z
from the remote cameras included in the selected camera group .
After entering the information on the "C001" to "C010" lines, click
[SET] button to reflect the changes .
13 ALARM
Displays the alarm information of the remote cameras .
It is displayed for the remote cameras belonging to the camera
group selected on the unit .
For remote cameras with a serial connection, the information is only
displayed when a remote camera is selected on the unit .
14 RENEW button
Executes "RENEW IP ADR" in AUTO IP menu [37] of the unit .
When you click [RENEW] button, the link setting targets (camera
numbers and switcher) corresponding to the remote cameras and
switcher newly detected by the unit are displayed in yellow .
If you click [SET] button next, the settings are confirmed and the IP
addresses of the remote cameras and switcher are updated .
If you click [CANCEL] button, the settings are not reflected .
16 17
15 KEEP button
Executes "KEEP IP ADR" in AUTO IP menu [37] of the unit .
When you click [KEEP] button, the link setting targets (camera
numbers and switcher) corresponding to the remote cameras
and switcher newly detected by the unit are displayed in yellow .
If you click [SET] button next, the settings are confirmed and the
connection destination IP addresses of the unit are updated .
If you click [CANCEL] button, the settings are not reflected .
16 REFRESH button
Loads the connection information set on the unit to the personal
computer and refreshes the display on the "Setting" tab .
17 ALL CLEAR button
Executes "ALL CLEAR" in AUTO IP menu [37] of the unit .
When you click [ALL CLEAR] button, the connection types and the
connection destination IP addresses set on the unit are initialized .
z When a connection type is set to "Network", it is changed to
z
"NoAsign" . When a connection type is set to "Serial", it is not
changed .
18 SET button
Confirms the changes on the "Setting" tab and updates the settings
on the unit .
19 CANCEL button
Cancels the settings that were configured on the "Setting" tab .
12 13
18 19
49