Recalling Tracing Memory (Recall) - Panasonic AWRP120 Operating Instructions Manual

Operating tracing memory (TMEM)
6 .
Hold down one of the number buttons [1] to [10] that
has its indicator turned off to specify the tracing
memory number .
The current camera position and settings are registered to the preset
memory of the remote camera, and become the start position and
settings at the time of recalling .
The indicators of the number button that was held down and START
button [11] blink . (Recording standby state)
z If an operation that is target for recording such as moving the PAN/
TILT lever is performed at that time, the recording standby state is
canceled and the status returns to that of step 3 .
Tracing memory number
TM 0 5 :
St a n d b y S t o r e
Notes
z If you want to register tracing memory to a button whose
z
indicator is on, delete the registered tracing memory and then
register the new tracing memory .
z If a button with the same number as a registered preset
z
memory is held down, the saved preset memory will be
deleted as it will be overwritten .
7 .
Press START button [11] .
The indicator of START button [11] turns on . (Operation wait state)
TM 0 5 :
Wa i t i n g O p r .
8 .
Operate one of the PAN/TILT lever, ZOOM button,
FOCUS dial, IRIS dial, and white balance mode selection
buttons .
The recording of tracing memory starts from the point in time that the
operation began .
Recording time
TM 0 5 : 0 m 0 2 s
St o r i n g...
9 .
Press STOP button [12] .
Recording stops and the tracing memory is saved .
The registered number button turns on and the status returns to that
of step 3 .
z When the possible recording time elapses, recording stops
automatically .
At that time, operations up until the point in time that recording
stops are recorded .
(continued)

Recalling tracing memory (RECALL)

1 .
2 .
3 .
4 .
Tracing memory number
5 .
Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be operated .
Press the TMEM button to turn on its indicator .
The tracing memory status appears .
The indicators of number buttons with registered tracing memory
turn on .
Selected camera number
CAM01:TMEM
3m50s Remained.
Remaining possible recording time (max . 5 m 00 s)
Note
z A button with no tracing memory registered does not turn on
z
even when it is a button with preset memory registered .
Press one of the number buttons that has its indicator
turned on to specify the tracing memory number .
The remote camera moves to the start position .
The indicators of the number button that was pressed and START
button [11] blink . (Recall standby state)
TM03:0m00s
Standby Recall
Press START button [11] .
The tracing memory is recalled and the remote camera starts
moving .
The indicator of START button [11] turns on .
Current recall
position
TM03:0m20s
Recalling...
When the recording time elapses, the remote camera
stops automatically .
The number button that was blinking turns on, the indicator of
START button [11] turns off, and the process returns to step 2 .
z Pressing the STOP button [12] or performing an operation that
is target for recording such as moving the PAN/TILT lever during
recalling will stop recalling and return the process to step 2 .
Total time of tracing
memory during recalling
19