Operating Tracing Memory (Tmem); Registering Tracing Memory (Store) - Panasonic AWRP120 Operating Instructions Manual

Operating tracing memory (TMEM)

The unit incorporates tracing memory (TMEM) for recording a series of
operations that were performed for a connected remote camera .
This feature allows you to duplicate the recorded operations of a remote
camera .
<Tracing memory>
Recording target Camera numbers CAM1 to CAM10
Functions that Pan, tilt, zoom, focus, iris, and white balance
can be recorded mode
Recording time Up to 5 minutes per camera
Number of Up to 10 per camera
recording
memory
Record buttons Number buttons [1] to [10]
Notes
z If the MEM ENABLE button indicator is off, tracing memory
z
operation is not possible . Perform operation while the button
indicator is on .
z Preset numbers PMEM 1 to 10 of the preset memory are used
z
as start positions at the time of recalling tracing memory so they
are overwritten when the tracing memory registration operation is
performed .
z The last point when tracing memory is recalled may not match
z
that at the time of recording because of the error of movement of
the remote camera .
Taking precautions such as the following can help reduce the
error .
• Use the lens zoom at the WIDE side (wide‑angle end) .
• Perform pan, tilt, zoom, and focus operations slowly .
• Set a short recording time .
Execute tracing memory recalling several times to sufficiently
check the operation of the remote camera before you begin
operation .
<Tracing memory operation section>
MEM DELETE button
MEM STORE button
START button [11] Number buttons [1] to [10]
STOP button [12]
18
TMEM button
RESTORE button
MEM ENABLE button
MEM SETTING button

Registering tracing memory (STORE)

1 .
Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be operated .
2 .
Output the images to be shot to the monitor .
3 .
Press the TMEM button to turn on its indicator .
The tracing memory status appears .
The indicators of number buttons with registered tracing memory
turn on .
Selected camera number
CAM01:TMEM
3m50s Remained.
Remaining possible recording time (max . 5 m 00 s)
Note
z A button with no tracing memory registered does not turn on
z
even when it is a button with preset memory registered .
4 .
Press the MEM STORE button to turn on its indicator .
5 .
Operate the PAN/TILT lever and ZOOM button to
determine the camera angle to register .
If necessary, adjust the focus, iris, and white balance as well .
z To record the focus operation and iris operation to tracing memory,
press the auto focus button and auto iris button to turn off their
indicators and then perform the operations .