Deleting Tracing Memory (Delete); Restoring Tracing Memory (Restore) - Panasonic AWRP120 Operating Instructions Manual

Operating tracing memory (TMEM)

Deleting tracing memory (DELETE)

1 .
Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be operated .
2 .
Press the TMEM button to turn on its indicator .
The tracing memory status appears .
The indicators of number buttons with registered tracing memory
turn on .
Selected camera number
C A M 01 : T M E M
3 m 5 0s R e m a i n e d .
Remaining possible recording time (max . 5 m 00 s)
Note
z A button with no tracing memory registered does not turn on
z
even when it is a button with preset memory registered .
3 .
Press the MEM DELETE button to turn on its indicator .
4 .
Hold down one of the number buttons [1] to [10] that
has its indicator turned on to specify the tracing
memory number .
The registered preset memory (start position) and tracing memory
are deleted .
20
(continued)

Restoring tracing memory (RESTORE)

Some of the recorded tracing memory data can be overwritten .
For example, you can record just the ZOOM operation again while
leaving the data recorded for the PAN/TILT operation as is . Or you can
leave the data for the first half of the recorded PAN/TILT operation as is
and record just the second half of the operation again .
z It is not possible to correct just an arbitrary section of recorded tracing
z
memory data .
1 .
2 .
3 .
4 .
5 .
Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be controlled from the unit .
Output the images to be shot to the monitor .
Press the TMEM button to turn on its indicator .
The tracing memory status appears .
The indicators of number buttons with registered tracing memory
turn on .
Selected camera number
CAM01:TMEM
3m50s Remained.
Remaining possible recording time (max . 5 m 00 s)
Note
z A button with no tracing memory registered does not turn on
z
even when it is a button with preset memory registered .
Press the RESTORE button to turn on its indicator .
Press one of the number buttons [1] to [10] that has its
indicator turned on .
The remote camera moves to the start position .
The indicators of the number button that was pressed and START
button [11] blink . (Restore standby state)
z At this time, you can operate the PAN/TILT lever to change the
start position .
TM03:0m00s
Standby Restore