Memory Card Operations - Panasonic AWRP120 Operating Instructions Manual

Memory card operations

The unit allows you to use a memory card to perform the following
operations .
SAVE : Save the configuration data of the unit or a remote camera to a
memory card .
LOAD : Load the configuration data saved to a memory card to the unit
or a remote camera .
<Data Target for SAVE and LOAD>
Data
Description of data
type
Configuration data of
RPDAT
unit * 2
Configuration data stored
CAM
on the remote cameras *
Memory related data
RPMEM
stored on the unit *
UPG Unit version update file
LOG Unit operation log
* 1 : When SAVE is executed on the unit, the file names above are
assigned automatically .
Also, after SAVE is executed on the unit, the file names can be
changed with a personal computer .
z About file names
z
RPDAT: ******** .s12
******** .c12
CAM:
RPMEM: ******** .m12
Use "up to eight single‑byte alphanumeric characters" for the
******** part above . A file name other than the above may not be
displayed properly on the unit .
* 2 : The IP address, subnet mask, default gateway settings of the unit
and the user authentication settings (user name and password) are
not target for the SAVE and LOAD operations .
* 3 : Only the following data for one selected remote camera is target for
SAVE and LOAD .
z Settings of each shooting mode (scene file)
z
z Preset memory data
z
z System settings
z
* 4 : The following data is target for SAVE and LOAD .
z Tracing memory data
z
All data of camera numbers CAM1 to CAM10
z PRESET SPEED
z
PRESET SPEED values set for all preset numbers of camera
numbers CAM1 to CAM100
36
SAVE/
File names * 1
LOAD
RP01 .s12 to SAVE and
RP99 .s12 LOAD
RP01 .c12 to SAVE and
3 RP99 .c12 LOAD
RP01 .m12 to SAVE and
4 RP99 .m12 LOAD
V***** .r5d to
LOAD only
V***** .r5d
RP01 .log to
SAVE only
RP99 .log
Notes
z SAVE and LOAD are not possible with the CAM item of a camera
z
connected via a serial connection .
z Preset memory data is not included in "RPMEM" .
z
Therefore, when a different remote camera than the one when
SAVE was executed is connected, just loading "RPMEM" to the
unit will not result in the start position being recalled when the
tracing memory is recalled .
When replacing a remote camera, also execute SAVE and LOAD
of "CAM" .
Precautions on handling memory cards
z Never remove a memory card while the memory card access lamp
z
is lit or blinking .
If you remove a memory card while the memory card access lamp
is lit or blinking, the data saved to the memory card may be lost .
z The data stored in a memory card may be lost due to, for example,
z
the loss or incorrect operation of the memory card .
We recommend saving any important data to a computer or other
device .
z Memory cards
z
Memory cards used with the unit should conform to SD or SDHC
standards .
Be sure to use the unit to format memory cards .
Memory cards with the following capacity can be used with the
unit .
SDXC memory cards and MultiMediaCards (MMC) are not
supported .
SD 8 MB to 2 GB
SDHC 4 GB to 32 GB
For the latest information not described in the Operating
Instructions, refer to the following websites .
http://pro‑av .panasonic .net/
z Observe the following points when using and storing the
memory cards .
• Avoid high temperature and humidity .
• Avoid water droplets .
• Avoid static electricity .