Setting The Operation Items For When Preset Memory; Is Recalled (Preset Scope); Setting The Speed At Which To Move To The Position Set In The Preset Memory (Preset Speed) - Panasonic AWRP120 Operating Instructions Manual

Operating preset memory (PMEM)
Setting the operation items for when preset
memory is recalled (PRESET SCOPE)
You can select whether to recall all or only some of the settings
registered to preset memory .
Note
z This function is enabled when AW‑HE50, AW‑HE60, or
z
AW‑HE120 is selected .
1 .
Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be operated .
2 .
Press the PMEM button to turn on its indicator .
3 .
Press the MEM SETTING button .
The setting of the selected remote camera is displayed .
S P E E D
S C O P E
z If approximately 3 seconds elapses without an operation being
performed, the previous LCD panel display is redisplayed .
4 .
Turn the F2 dial to select a setting for the "SCOPE" item
from MODE A to MODE C, and then press the F2 dial to
confirm the selection .
The setting of the remote camera is changed .
This is applied the next time the preset memory is recalled .
<SCOPE settings and recalled items>
Setting
Pan, tilt, zoom,
and focus
MODE A √
MODE B √
MODE C √
Note
z MODE A to MODE C are not registered to the remote camera
z
preset memory or the unit . The settings become the common
settings for when preset memory is recalled, and the same
settings are applied regardless of which preset number is
selected .
14
(continued)
: 3 0
: M O D E A
Recalled item
White balance
Iris settings,
Gain
√ √
√ —
— —
√: Recalled —: Not recalled
Setting the speed at which to move to
the position set in the preset memory
(PRESET SPEED)
The speed (PRESET SPEED) at which to move to the set position when
preset memory is recalled can be set from the unit .
With this unit, you can select from the following two PRESET SPEED
recall modes .
z Move at the common PRESET SPEED set for the remote cameras .
z
z Move at the PRESET SPEED registered for each preset number of
z
the unit .
This allows the remote cameras to be operated at a different speed for
each preset number depending on operation, enabling video playback at
a variety of speeds .
Note
z The movement speeds registered in the procedure below are
z
registered to the corresponding camera numbers in the unit, and
are not registered to the preset memory of the remote cameras .
Therefore, if the recall mode is set to "On" and the preset memory
is recalled on a controller other than the AW‑RP120 on which the
movement speed was registered, movement will be at a different
speed even in the case of the same preset number .
Setting PRESET SPEED on remote cameras
1 .
Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be operated .
2 .
Press the PMEM button to turn on its indicator .
3 .
Press the MEM SETTING button .
The setting of the selected remote camera is displayed .
SPEED
SCOPE
z If approximately 3 seconds elapses without an operation being
performed, the previous LCD panel display is redisplayed .
Note
z When a remote camera other than AW‑HE50, AW‑HE60,
z
or AW‑HE120 is controlled, the last value set for the
corresponding remote camera on the unit is displayed .
4 .
Turn the F1 dial to select the setting of the "SPEED"
item, and then press the F1 dial to confirm the selection .
The PRESET SPEED value is set on the remote cameras .
The following shows the relationship between the set value and the
speed at which the remote camera moves to the set position when
preset memory is recalled .
1 30
Slow Fast
: 30
: MODE A