Removing The Upper Housing - Epson Stylus COLOR 1160 Service Manual

EPSON Stylus COLOR 860/1160

4.2.1 Removing the Upper Housing

Since the printer mechanism itself structures the bottom part, the printer
mechanism appears just by removing the Upper Housing.
1. Open the printer cover and turn the PG adjustment lever towards (+) side.
2) Remove 4 screws (No.8) securing the Upper Housing, and remove it
upward. Refer to Figure 4-2. The left column's photos show you the Stylus
Color 860 and right column's photos show you the Stylus Color 1160.
Lift up and remove the Upper Housing, pulling it forward.
(Since it collides with the carriage)
After assembling the Upper Housing, confirm the Head FFC is
placed in the gutter which is located at the back side of the of
the Upper Housing.
In case the Head FFC is not placed in the gutter, it may
damage the head FFC.
Disassembly and Assembly
Stylus COLOR 860
No.8 Screws
Figure 4-2. Removing the Upper Housing
Disassembly Procedures
Stylus COLOR 1160
Upper Housing
No.8 Screws
Revision C
No.8 Screws
No.8 Screws
80