Epson Stylus COLOR 1160 Service Manual page 154

EPSON Stylus COLOR 860/1160
Table 6-2. Lubrication Point (continued)
No. Standard
<Lubrication Point>
Oil pad in the carriage assembly
<Lubricant Type> O-12
<Lubrication Amount>
15
0.72 ~ 0.77cc (0.65 ~ 0.69g)
Note:
This is the amount to be applied to a
new oil pad.
<Lubrication Point>
Shaft for "FRAME, LEFT"
16 <Lubricant Type> G-26
<Lubrication Amount>
1 x 5mm
<Lubrication Point>
Inside of the right hole of "FRAME,
ASF; B"
<Lubricant Type> G-26
17
<Lubrication Amount>
1 x 1mm
Apply grease evenly to the inside of the
hole.
<Lubrication Point>
Left and right edges of "HOPPER
ASSEMBLY; C"
18
<Lubricant Type> G-26
<Lubrication Amount>
2mm-diameter ball
Maintenance
Remarks
Lubricate the oil pad only when:
• Replacing the carriage assembly
• Replacing the oil pad
Use a precise syringe to apply oil. If
you accidentally apply too much oil
to the oil pad, throw the pad away
and take a new one again.
Leave the pad for a while to wait
until oil is evenly infiltrated, then
install it on the carriage assembly.
See p. 154.
Use a brush to apply grease.
See p. 154.
Use a brush to apply grease.
See p. 154.
Overview
Table 6-2. Lubrication Point (continued)
No. Standard
<Lubrication Point>
"GUIDE PLATE, CR" (the part where
the carriage slides on.)
19
<Lubricant Type> G-26
<Lubrication Amount>
1 x approx. 270mm
Revision C
Remarks
See p.155.
154