Removing The Upper Housing Assembly - Epson TM-FX2180 Service Manual

EPSON FX-2180 Service Manual

4.2.7 Removing the Upper Housing Assembly

Remove the printer cover, rear edge guide assembly, paper eject
1.
assembly, and rear tractor unit. (See section 4.2.1.)
Remove the panel board assembly. (See section 4.2.2.)
2.
Remove the four CBB screws (4
3.
assembly. (Figure 4-13 shows the screw locations.)
4. Remove the platen knob.
Release the two hooks from the holes on both sides of the upper
5.
housing assembly near the front, and release the tab in the middle
front of the upper housing assembly. Then lift up the front of the upper
housing assembly.
tab
Figure 4-12. Releasing the Upper Housing Assembly Hooks and Tab
4) securing the upper housing
Remove the upper housing assembly.
6.
Figure 4-13. Removing the Upper Housing Assembly
IMPORTANT
The tightening torque for the four CBB screws is
0.98 - 1.22 Nm (10 - 12 Kgf-cm).
Chapter 4 Disassembly and Assembly
4-10