Remedies For Paper Out Error - Epson Stylus COLOR 1160 Service Manual

Color ink jet printer
Hide thumbs Also See for Stylus COLOR 1160:
Table of Contents

Advertisement

EPSON Stylus COLOR 860/1160

3.1.1.1 Remedies for Paper Out Error

This section provides check points and corresponding actions which are
necessary when the Paper Out Error problem has occurred because of
either of the following reasons:
n Paper is set in the ASF hopper but not fed.
n Paper is fed but not detected by the PE sensor actuator.
Be sure to follow the steps in the order described in the tables.
NOTE: If the finding the detail phenomenon which fits the defective
printer, take the Check & Action described in the right column.
If "No", proceed to the next step.Remedies for Paper Error.
Troubleshooting
Table 3-5. Remedies for Paper Out Error
Step
Detail Phenomenon
1
When the Paper
Feed SW is pressed,
the ASF LD roller
attempts to feed the
paper. But the paper
is not loaded.
After that, the Panel
LED indicates the
Paper Out Error.
2
When the Paper
Feed SW is pressed,
the ASF LD roller
feeds the paper to
the PF roller.
But, ASF LD roller
rotates again and the
PF roller advances
the paper over the
TOF position.
After that, the Panel
LED indicates the
Paper Out Error.
3
Ditto
Overview
Check & Actions
Set a cleaning sheet in the ASF up side down. Then
holding the top edge, press the Load/Eject button, and
the micro pearl on the paper load roller (a semicircular
roller) surface is removed. To remove severe smear,
staple a cloth moistened with alcohol to a post card and
clean the roller in the same manner.
Check if the connector (yellow, 3-pin) for the PE sensor
is connected to PE sensor or CN5 on the Main Board.
• Using your hand, try activating the actuator in the
same condition as it is detecting incoming paper. Then
release the actuator and check if the actuator
automatically returns to its original position with the
tension of the spring.
• Referring to the illustration above, check that the
sensor base is securely installed to the frame. If the
sensor base is floating or installed insecurely, instal it
securely.
Revision C
57

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stylus color 860

Table of Contents