Epson Stylus COLOR 1160 Service Manual page 148

EPSON Stylus COLOR 860/1160
3. Set the small column to the shaft hole of the PF Loop scale and put
the PF Loop scale on the Base plate. The printed character side of
the PF Loop scale should be faced to the Base plate.
AS -Tool
1051765
Figure 5-54. Put the PF Loop scale on the Base plate
4. Press the PF Loop scale against the Base plate carefully and stick
the PF Loop scale to the Base Plate.
Do not touch the following portion.
- Inside of PF Loop scale shaft hole
- Character printed side of the Loop scale
It is no problem if the outline of the Base plate
dose not just fit to the printed circled line of the
PF Loop scale. Refer to Figure 5-55
Adjustment
This setting face is NG
This setting face is
Side view
correct
Loop scale
AS-Tool 1051765
Base plate
PF Loop scale unit assembling procedure
5. Peel off the protection tape from the adhesive tape (double side)
and stick it inside the printed circled line on the PF Loop scale.
Adhesive tape
Protection tape
Adhesive tape
Figure 5-55. Sticking the Protection Tape to the PF Loop Scale
It is not problem if the out line of the Adhesive
tape dose not just fit to the printed circled line of
the PF Loop scale.
Revision C
148