Epson Stylus COLOR 1160 Service Manual page 153

EPSON Stylus COLOR 860/1160
Table 6-2. Lubrication Point (continued)
No. Standard
<Lubrication Point>
"SHAFT, PULLEY, DRIVEN"
6
<Lubricant Type> G-26
<Lubrication Amount>
1 x 1mm
<Lubrication Point>
Inside of "COMBINATION GEAR, 12,
22.4"
7 <Lubricant Type> O-12
<Lubrication Amount>
Apply oil evenly to the inside of the
gear.
<Lubrication Point>
Inside of "COMBINATION GEAR, 14,
28"
8 <Lubricant Type> O-12
<Lubrication Amount>
Apply oil evenly to the inside of the
gear.
<Lubrication Point>
Center of Pole C (2 places)
<Lubricant Type> G-26
9
<Lubrication Amount>
1 x 3mm
<Lubrication Point>
"FELT, D3.6"
10
<Lubricant Type> O-12
<Lubrication Amount>
Full (but not overfull)
Maintenance
Remarks
See p. 152.
Use a dispenser to apply oil.
See p. 152.
Use a dispenser to apply oil.
See p. 152.
See p. 152.
Wipe off any oil leaking into the
motor side.
See p. 152.
Overview
Table 6-2. Lubrication Point (continued)
No. Standard
<Lubrication Point>
Groove of "ROLLER, PF"
11 <Lubricant Type> G-26
<Lubrication Amount>
1 x 5mm
<Lubrication Point>
Contact point between "ROLLER,
EJECT" and "GROUND SPRING,
EJECT"
12
<Lubricant Type> G-26
<Lubrication Amount>
1 x 2mm
<Lubrication Point>
Bearing of "PAPER GUIDE, REAR",
and contact point between "ROLLER,
PF" and the rotating gear of "Roller, PF
Unit"
13
<Lubricant Type> G-26
<Lubrication Amount>
1 x 1/2 turn
<Lubrication Point>
"PAPER GUIDE, FRONT" (3 places)
<Lubricant Type> G-26
14
<Lubrication Amount>
1 x 2mm (Roller Eject side)
1 x 2mm (Roller Eject side)
1 x 10mm (Roller PF side)
Revision C
Remarks
See p. 152.
See p. 152.
Apply grease while rotating the
"Roller, PF Unit".
See p. 153.
See p. 153.
153