Epson Stylus COLOR 1160 Service Manual page 106

EPSON Stylus COLOR 860/1160
7) Move the PG Lever to bring its hooks to the wider areas of the cutouts in
the right side of the Top Frame. Then remove the PG Lever by releasing
the hooks.
Right side of the
Top Frame
Figure 4-46. Setting the Two Hooks
8) Using tweezers, remove the Torsion Spring 63.7 hung onto the right side of
the Top Frame and PG lever. Refer to Figure 4-47.
9) Release the fixed hook of the PG Lever Support, then remove the PG
Lever Support and Disk Spring (6.2x0.15x1, S/NA) from the right end of the
CR Guide Shaft. Refer to Figure 4-47.
Torsion Spring 63.7
Figure 4-47. Removing the Torsion Spring 63.7 & PG Lever
Disassembly and Assembly
PG Lever
Bring the hooks to
these areas.
No. 7 Screw
Disk Spring
PG Lever Support
Disassembly Procedures
10) Remove one screw (No.7) and rotate the Right Parallelism Adjustment
Bushing and move it forward to align the locking protrusion of the Right
Parallelism Adjustment Bushing with the notches in the right side of the
Top Frame.
Notches in the Top
Frame
Figure 4-48. Removing the Right Parallelism AD Bushing
Be careful when removing the Right Parallelism Adjustment
Bushing. If you remove it with the printhead installed, the CR
Unit will fall to the platen.
Revision C
Right Parallelism
Adjustment Bushing
106