Epson Stylus COLOR 1160 Service Manual page 102

EPSON Stylus COLOR 860/1160
n
During disassembly and assembly of the hopper assembly,
do not let the grease on the cam parts touch other parts.
Wipe off any grease smeared on other parts.
n
Be careful of the direction of the Hopper Release Lever
when installing it. Refer to Figure 4-38.
n
Make sure that the following parts are installed steadily on
the left edge of the LD Roller Shaft.
- Left LD Roller Fixing Bushing (white plastic for SC860)
- Left LD Roller Fixing E-ring (for SC1180)
- ASF HP Detector Wheel (black plastic)
Refer to Figure 4-34, Figure 4-37.
n
When installing the right and left Paper Feed Roller
Assemblies to the LD Roller Shaft, make sure that the black
one goes to the right.
n
Make sure that gutters in the back of both Paper Feed Roller
Assemblies are set on the rail in the ASF Frame. Refer to
Figure 4-39.
n
After installing the Paper Feed Roller Assembly, be sure to
fit the groove in the Edge guide to the top left edge of the
right Paper Feed Roller Assembly. Refer to Figure 4-39-1.
n
Ensure that the right Paper Feed Roller Assembly is fixed
with the hook on the ASF unit. Check it from the back of the
ASF Frame. Refer Figure 4-40.
n
During assembly, when setting the compression spring
1.961 to the spring installation position in the Paper Feed
Assembly, hang the spring on the hook temporarily. Then,
do not forget to release these springs from the hooks
through the holes in the back of paper feed assembly by
rotating the springs. (Refer to theFigure 4-41.)
Disassembly and Assembly
Figure 4-38. Assembling the LD Hopper Release Lever
Paper Feed Roller Assembly
Fit the gutter of the Paper Feed Roller
Assembly to this rail in the ASF.
Figure 4-39. Fitting the Paper Feed Roller Assy. to the Rail
Disassembly Procedures
Revision C
Hopper Release Lever
102