4.12 Inner Forward Slide
1
50
2
3
4
5
6
7
8
The inner forward slide 1 folds the trim around the interior slide.
Then the center forward slide folds the trim around the inner forward
slide.
The inner forward slide holds the folded trim tight when the interior
slides are pulled back. It is therefore pulled back into the initial
position 2° later.
Caution Risk of Injury !
Turn the main switch off.
Set the inner forward slide only with the sewing unit turned off.
Conduct a function test with the greatest possible caution.
Setting the position of the edge
–
Loosen screws 2 and 3.
–
Align the position of the inner forward slide with the carrier 8.
The trim edge should have a clearance of 1 mm to the pointed
seam.
–
Tighten screws 2 and 3 again.
Setting the position of the run-forward forward slide
–
Loosen screw 4.
–
Set eccentric 5.
The front edge of the inner forward slide should lie at the same
height as the beard clamp.
–
Tighten screw 4 again.
Setting the position of the run-back forward slide
–
Loosen screw 6.
–
Set eccentric 7.
The inner forward slide should have a clearance of 5 to 6 mm to
the interior slides.
–
Tighten screw 6 again.
Continued on the next page !